Product Features:

1. Using electronic switches, can effectively reduce consumption, to solve the traditional mechanical switches exist as a result of poor contact and other issues caused by shock or oxidation, to ensure normal supply of the receiver and servos and safety.

2. Integrated battery voltage display, voltage shortage prompts, low voltage protection function.

3. Consistent with AMB sensor mounting holes, easy to install.

4. Waterproof, dustproof design to adapt to harsh environments.

5. Digital display, various functional parameters clear.

Technical Parameters:

Voltage:  4.8-13V

Current:  0-15A

Weight:  12g

Size:  23x19x15mm

Function Help:

1.   Open, close, and settings:

      Tap the power button to turn on the electronic switch, digital displays the following: Set voltage value (blinking) --- Mode (blinking) --- Access into the working status display battery voltage

      Press the power switch more than 2 seconds to turn off the electronic switch.

     In the open or closed state, press the power switch more than four seconds to enter the setup mode, Set alarm voltage(Arbitrarily set between 4.2-12V), After the setup is complete wait three seconds into the working mode selection, In F1, F2, F3 choose between, Select Done wait three seconds to exit the setting mode automatically.

2.   Features:

      F1 (low voltage prompt): When the input voltage drops below the set voltage, Voltage digital display flashes, Output connector normal output. (If you do not replace the new battery, when the battery voltage is slowly picking up, higher than the set voltage, digital still keep flashing, this will alert the user, and the battery voltage has appeared under voltage)

    F2 (low voltage reminder): When the input voltage drops below the set voltage, Voltage digital display flashes, the output will appear open 3 seconds, turn off 0.5 seconds. (If you do not replace the new battery, when the battery voltage is slowly picking up, higher than the set voltage, digital still keep flashing, this will alert the user, the battery voltage has appeared under voltage, Power output will return to normal output)

    F3 (low voltage protection): When the input voltage drops below the set voltage, Tap the power switch to turn, digital displays F3 flashing, Prompts the user to input voltage is too low, the output does not have the power output. In the course when the voltage drops below the set value, it will directly turn off the output, digital displays F3 flashing, prompts the user to input voltage is too low. (If you do not replace the new battery, when the battery voltage is slowly picking up, higher than the set voltage, digital still keep flashing, this will alert the user, the battery voltage has appeared under voltage, Output power is not restored to normal output)

     F2 (low voltage reminder), F3 (low voltage protection) these two modes can not be used for model airplanes as the main power control switch.

Kindly Remark:

1. Battery polarity cannot be reversed.

2. Voltage cannot exceed the operating voltage range of products, this will cause damage to the product.